This topic contains 1 reply, has 0 voices, and was last updated by 
-
Posts
-
I guess some of you made more of those cables than I did, so please correct me:
1 don’t forget to put the black rubber cable protection
2 strip 15mm
3 drill the shield to a wire and maybe put some tube on it
4 solder the CS1 contacts to the wires
5 insert all contact half ways into the RI8. numbers are printed on it.
the broader part of the contact is outside (no way to put it inverted)
1 brown 2 red, 3 orange/lila, 4 yellow, 5 green, 6 blue, 7 shield(GND), 8 black(+12V)
6 IMPORTANT: connect a female counterpart TI8 to guide the contact.
IF YOU DO NOT DO THIS, look what can happen: http://youtu.be/PNEqESIPqcE
7 fully insert all contacts
8 mount SC8 and SR8
options: http://www.neutrik.com/en/industrial/circular-connectors/neutricon/neutricon-modular-system/
You must be logged in to reply to this topic.